9 of the AMBER (type 5050) LED mounted on a 40mm² PCB board.
Suitable for 12 volt and 24 volt systems..
An efficient replacement for incandescent lamps in situations where the LED board can be laid directly into or on top of the diffused lens.
These boards generate virtually no heat and can be fixed using double sided tape, a small blob of silicon sealant or some other method.
You can attach the LED board straight to a hard surface as there is actually nothing under the board apart from the wire running away from the centre.
All of the circuitry is in line in a shrink-wrapped section about 100 mm back from the board.
It's not set up to flash - it will flash (see below) however if you wire it into your automotive system to replace an existing bulb
A no-load electronic flasher will still be required if you change your indicator system all over to LED - please see "Related Products" tab.
Suitable for 12v and 24vDC systems (even under charge).
Operating voltage range - 8~30vDC
Current draw at 12vDC - 190 milliamps
Viewing Angle - 120°
Size of PCB board - 40 mm square
Total thickness of PCB including LED - 3 mm
Thickness of PCB board - 1.6 mm