LED Amber board 80x40mm 12v - suitable for indicators, bug-resistant lighting.
18x5050 AMBER LED mounted on a 80x40mm PCB board.
Economical and easy replacement in situations where hard to find AMBER bulbs can be replaced with an efficient LED board.
Suitable for 12 volt and 24 volt systems - (Please do not cut between the inline driver and the LED board).
An efficient replacement for incandescent lamps in situations where the LED board can be laid directly on top of the diffused lens.
These boards generate virtually no heat and can be fixed using double sided tape, a small blob of silicon sealant or some other method.
You can attach the LED board straight to a hard surface as there is actually nothing under the board apart from the wire running away from the centre.
It's not set up to flash - it will flash (see below) however if you wire it into your automotive system to replace an existing bulb
A no-load electronic flasher will still be required if you change your indicator system all over to LED - please see "Related Products" tab.
All of the circuitry is in line in a shrink-wrapped section about 100 mm back from the board.
Suitable for 12v and 24vDC systems (even under charge).
Operating voltage range - 8~30vDC
Current draw at 12vDC - 380 milliamps
Luminous flux - 240 lm
Kelvin temperature - 6000 K.(Cool White)and 3000K (Warm White)
Viewing Angle - 120°
Size of PCB board - 80x40 mm
Total thickness of PCB including LED - 3 mm
Thickness of PCB board - 1.6 mm